Skip to content
ESP3D Logo ESP3D Ecosystem

[ESP109]

Set / Display station rejoin from the setup fallback, which can be ON or OFF

When the station connection fails and the station fallback mode is WIFI-SETUP (see [ESP104]), ESP3D starts the setup access point. If this setting is ON, ESP3D then looks for the station network every 2 minutes, but only while no client is connected to the setup access point, so a user configuring the board is not disconnected. When the configured SSID is visible again, ESP3D restarts the network and reconnects to it. If this attempt fails, it goes back to setup mode as before.

These messages are sent to all clients, including serial:

  • Waiting for STA network when the setup fallback starts with this setting ON
  • STA network found, reconnecting when the station network is visible again

Default value is OFF.

Input

Section titled “Input”

[ESP109](state) json=(no) pwd=(admin/user password)

  • json=no the output format can be in JSON or plain text

  • pwd=(admin password) the admin password if authentication is enabled

  • state

    • if state is empty, it will display current state
    • if state is not empty, it will set the state: ON or OFF

Output

Section titled “Output”
  • In json format
{
   "cmd":"109",
   "status":"ok",
   "data":"OFF"
}
  • cmd Id of requested command, should be 109
  • status status of command, should be ok
  • data content of response, here the state