[ESP935]

Set / Display native USB CDC client state

Only available on boards using native USB as serial port: ESP32-S2/S3/C3/C6 built with USB_CDC_CLIENT_FEATURE and ARDUINO_USB_CDC_ON_BOOT=1. See USB.

Input

[ESP935](state) json=(no) pwd=(admin/user password)

• json=no the output format can be in JSON or plain text

• pwd=(admin password) the admin password if authentication is enabled

• state

  • if state is empty, it will display current state and if a host is connected
  • if state is not empty, it will set the state:
    • ENABLE: enable the client and start it now
    • DISABLE: disable the client, applied at next boot (or use CLOSE)
    • CLOSE: stop the client until next boot or ENABLE, the answer is sent before the client is stopped

Output

• In json format

{
   "cmd":"935",
   "status":"ok",
   "data":"ENABLED - Connected"
}

• cmd Id of requested command, should be 935
• status status of command, should be ok
• data content of response, here the current state

• plain text format

ENABLED - Connected